Maintenance - Galvamet Exclusive THEOREMA Maintenance Instructions Manual

Table of Contents

Available languages

P6 to switch Air exchange on/off – Extractor running 5 minutes every 25 minutes in first speed for 24 hours maximum; during operation the

button flashes, otherwise the light is on continuously. It is possible to deactivate the function at any time by selecting P2 (P6 must be

deactivated and the corresponding symbol switched off; to reactivate the function, press P6 again).

A bleep every time a button is pressed confirms the message has been received. If P2 is switched off, pressing P3, P4, P5 must not activate

any bleeping.

Adjustable and delayed self switching off

With the hood ON, select the desired speed, then keep the button of the speed corresponding to the desired minutes of self-power off

pressed until it flashes, taking the following into account:

P2 equals 5 minutes

P3 equals 10 minutes

P4 equals 15 minutes

With the operation with self-power off it is possible to modify the set speed.

IF MAXIMUM POWER IS SELECTED AFTER 5 MINUTES THE SPEED SWITCHES AUTOMATICALLY TO 3RD AND SELF-POWER OFF WILL TAKE PLACE IN

3RD SPEED.

If the selection of the switch-off time matches the set speed, the speed LED flashes; if the selection is different, the speed LED remains

fixed.

Filters maintenance reminder

Every 30 hours' operation, when the hood is switched off, all the LEDs (P1, P2, P3, P4, P5, P6) switch on continuously for 30 seconds, to warn

that it is necessary to clean the aluminium anti-grease filter. To clear the timer, keep P2 pressed with the extractor off until it bleeps,

otherwise the warning will be repeated next time the hood is switched off.

Every 60 hours' operation, when the hood is switched off, all the LEDs (P1, P2, P3, P4, P5, P6) flash for 30 seconds, to warn that it is necessary

to regenerate/wash the active charcoal filter and clean the aluminium anti-grease filter. To clear the timer, keep P2 pressed with the

extractor off until it bleeps, otherwise the warning will be repeated next time the hood is switched off.

Every 480 hours' operation, when the hood is switched off, all the LEDs (P1, P2, P3, P4, P5, P6) flash intermittently for 30 seconds (two flashes

and one pause), to warn that it is necessary to replace the active charcoal filter and clean the aluminium anti-grease filter. To clear the

timer, keep P2 pressed with the extractor off until it bleeps, otherwise the warning will be repeated next time the hood is switched off.

Always disconnect the hood from the mains before carrying out any maintenance or cleaning operation.

Particular attention should be paid to the metallic anti-grease fi

anti-grease fi

must be washed at least once a month with detergent in hot water (or in the dish-washer).

ATTENTION: the grease collected in the fi

regular basis as per instructions.

The activated charcoal fi

The charcoal fi

are positioned behind the anti-grease fi

Charcoal fi

can be washed in the dishwasher at a high temperature. DO NOT use dishwasher detergent. It is recommended

not to put anything else in the dishwasher along with the charcoal fi

Reactivate the fi

in the oven for 10 minutes at 100°C.

To substitute the metallic filters, lift the glass door and remove the metallic filters (Fig. 3). Press the buttons (H) to remove the plates (Fig. 4-I).

Now you can reach the charcoal filters, turn them, as indicated in Fig. 4, until the extractor is released and substitute them with the new

ones. Replace the plates (I), press again the buttons (H) to fix them.

The cooker hood must be cleaned frequently both internally and externally (at least once a month).

Do not let dirt gather on the inner and outer surfaces of the hood.

To clean the exterior of the hood do not use either acid or basic products, or abrasive sponges.

Clean the hood with a sponge dampen in warm water and a little quantity of neutral detergent (for example dishwasher detergent), in

order to remove possible particles of grease.

Rinse with a damp cloth, removing all the detergent carefully, following the satin finish direction on the steel surface. Drying is very

important, especially in areas where water is particularly hard and leaves limestone.

The present instruction manual is an integral part of the appliance itself, therefore it must be carefully kept and ALWAYS accompany it, even in case

of its assignment to another owner or user or in case the cooker hood is moved to another installation plant.

Any eventual adjustment to the electrical system, which may be necessary to install the cooker hood, must be carried out only by competent

people. Any repair carried out by no competent people may cause damages. For any repair or needed technical action make reference to a

Technical Assistance Center, which is authorized to carry out the replacement of the spare parts.

Always make sure that all the electrical parts (lights, exhaustion unit) are disconnected when the appliance is not in use.

By storms take off the main switch of the house electrical system.

The using of the cooker hood must not be other than the use of exhausting units for cooking damps on domestic kitchens. The manufacturer does

not accept any liability for damages caused by people, animals or things, by installation and maintenance mistakes or by any illegitimate use.

Make sure that the voltage (V) and the frequency (Hz) ratings indicated on the plate inside the cooker hood correspond to the ones available in

the installation place.

We remind that the use of products functioning with electrical energy implies the observance of some essential security rules, as follows:

• This equipment is not intended for people (children included) with reduced mental or motor capacities, with lack of experience or knowledge,

unless they are supervised or unless a person responsible for their security, gives them instructions regarding the use of the equipment. Children

must be supervised in order to be sure that they do not play with the equipment.

• Any cleaning action is forbidden if the appliance hasn't been disconnected from the main power supply and if the main switch of the house

electrical system is not off. If cleaning is not carried out according to these instructions, a fi may break out.

• Do not pull, take off or twist the cable coming out from the appliance, even though this has been disconnected from the main power supply.

• Do not sprinkle or throw any water directly on the appliance.

• Do not stick any sharp tool inside the exhausting holes and into the air discharge.

• Do not take out the filters in order to reach the internal sides of the appliance in case the main switch of the house electrical system is not off.

• Do not singe or flambé directly underneath the cooker hood. Take particular care when frying to ensure that the oil does not catch fi

can easily catch fi and it is therefore extremely important to clean the metallic fi

are designed to collect unpleasant odours in the cooking fumes. The air is then released purifi