Table of Contents
Advertisement
Single port Multiprotocol Fast Ethernet Print Server Hardware User
Indicator Test
Immediately upon power-up, all three indicators will show steady green
for several seconds. Then the LPT indicator will flash three times while
the Pw/Tx and Lk/Rx indicators remain steady. Irregularity of any
indicator during this test indicates that there is a problem with the
indicators themselves. Contact your dealer for correction of any
indicator problems before proceeding.
Circuit Tests
The circuit tests immediately follow the indicator test. A normal (no
fault) result is signaled by three flashes of the LPT indicator and the
start of normal print server operation.
If any error condition is found during the circuit tests, testing will halt
with the LPT indicator continuously signaling the particular error
according to the following table.
LPT Indicator Flash Pattern
steady long flashes
One long, two short flashes
One long, three short flashes
One long, four short flashes
One long, five short flashes
One long, six short flashes
One long, seven short flashes
One long, eight short flashes
One long, nine short flashes
steady short flashes
One long, eleven short flashes
In the event of a Firmware Reload Required error at startup, proceed
according to instructions given in the PS Admin Program User Guide
Unpacking and Installation
continuously on
Error Type
Firmware Reload Required
DRAM Error
Timer INT Error
Flash Protected
Flash ID Error
Flash Erase / Program Error
LAN Controller Error
LAN Memory Error
Parallel Controller Error
LPT Error
EEPROM Error
LAN I/O Base error
Guide
7
Advertisement
Table of Contents
