Power-Up And Self-Test - TRENDnet TE100-PS1plus Hardware User's Manual

Single port Multiprotocol Fast Ethernet Print Server Hardware User
1. Confirm proper operation of the printer to be connected to the Print
Server.
2. When you have confirmed proper operation of the printer, switch its
power off.
3. Confirm that your network is operating normally.
4. Connect the Print Server to the network through the RJ-45 jack on
the print server
WARNING:
5. While the printer is off, connect the Print Server directly to the
printer parallel port.
6. Switch printer power on.
7. Plug the AC power adapter
DC power input jack.
8. Plug the AC power adapter into an AC power outlet. This will supply
power to the Print Server. (The Print Server has no power switch.)
The Print Server

Power-up and Self-test

Whenever the Print Server is powered up, two testing procedures
follow automatically. The first procedure is a programmed series of
flashes intended to confirm proper operation of the three LED
indicators. The second procedure comprises programmed tests of the
Print Server internal circuitry. If any fault is found during the circuitry
tests, testing stops and a continuous pattern of flashes signals the
nature of the fault.
6
front panel.
Configuration problems may result if the
Server
is powered up without first establishing its
network connection. Follow this procedure to avoid
complications at the configuration stage.
self-test routines will proceed automatically.
output plug into the Print Server
Unpacking and Installation
Guide
Print