Table of Contents
Advertisement
6.
IR REMOTE CONTROL
The Matrix can be controlled by the IR Remote provided by pointing it di ectly at the IR sensor
on front panel. This allows for selecting inputs source) for each output (display) as well as
power On and O for connected CEC-enabled displays.
Note:
• While the ba ery is installed it is isolated from the internal contacts via a plastic tab. e
sure to remove this tab before operating the emote.
• While the remote contains Output 3 and 4 these have no function on this m trix.
Click to Power Off CEC-Enabled
Display of Output 1
Click to Power On CEC-Enabled
Display of Output 1
Assigning Inputs (sources) to Outputs (display):
1. On the remote locate the output to assign an input to, these are in order verticall from
top to bo om labeled in the middle of the remote.
2. Press the desired Input # or use the Previous
available inputs.
Virtual IR Code Supported by Default (Matrix Switching Code)
Code
Left (
Out1
0x57
Out2
0x1B
)
Right (
)
In1
0x41
0x09
0x11
0x17
Select Previous Input for Output1
Select Next Input for Output1
Select Specific Input for Output 1
Reserved
or Next
In2
In3
0x1D
0x1F
0x12
0x59
11
bu on to scroll through the
In4
0x0D
0x08
Advertisement
Table of Contents
