JVC KD-SH9750 Instructions Manual page 42

Notes:
• If you change the setting from "Off" to "On" while
playing a track, the tag display will be activated
when the next track starts playing.
• For MP3 tracks only: There are two versions–ID3v1
(ID3 Tag version 1) and ID3v2 (ID3 Tag version 2).
When both ID3v1 and ID3v2 are recorded, ID3v2
will be shown.
To change the FM tuner selectivity
—IF Filter
In some areas, adjacent stations may interfere
with each other. If this interference occurs, noise
may be heard.
• Auto: When this type of interference occurs,
this unit automatically increases the
tuner selectivity so that interference
noise will be reduced. (But the stereo
effect will also be lost.)
• Wide: Subject to the interference from adjacent
stations, but sound quality will not be
degraded and the stereo effect will not
be lost.
To change the AM/FM channel intervals
—Area
When this unit is shipped from the factory, the
channel intervals are set to 10 kHz for AM and
200 kHz for FM (US settings).
You will have to change the channel intervals
when using this unit in an area other than North
America and South America.
• US: Select when using this unit in North
or South America. (10 kHz for AM
and 200 kHz for FM)
• Europe: Select when using this unit in an
area other than North and South
America. (9 kHz for AM and 50 kHz
(for manual tuning) / 100 kHz (for
searching) for FM)
Note:
If the channel intervals settings are changed, the
names assigned to the stations will be erased from
memory. To reassign the names, see "Assigning
names to the sources" on page 44.
42
To turn on/off the key-touch tone—Beep
You can deactivate the key-touch tone if you do
not want it to beep each time you press a button.
• On: Activates the key-touch tone.
• Off: Deactivates the key-touch tone.
To select the external component to use
—Ext Input (Only for KD-SH9700)
You can connect the external component to the
CD changer jack on the rear using the Line Input
Adapter KS-U57 (not supplied).
To use the external component as the playback
source through this unit, you need to select
which component—CD changer or external
component—to use.
• Changer: To use the CD changer.
• Line In: To use the external component
other than CD changer.
Note:
For connecting the Line Input Adapter KS-U57 and
the external component, refer to the Installation/
Connection Manual (separate volume).
To turn on/off the line input switch
—Line In (Only for KD-SH9750)
You can switch off the line input when no external
component is connected to the LINE IN plugs.
• On: You can select "LINE IN" as the playback
source.
• Off: You cannot select "LINE IN" as the
playback source.
To turn on/off the power amplifier switch—
PowerAmp
You can switch off the built-in amplifier and send
the audio signals only to the external amplifier(s) to
get clear sounds and to prevent internal heat buildup
inside this unit.
• On: When not using external amplifier(s).
• Off: When using external amplifier(s).