Operation; Anti Tilt Protection - Westfalia NSB-150C5 Instruction Manual

Operation

1. Remove the heater out of the packaging and completely unroll the power
cord.
2. Place the heater on a level and solid surface.
3. Connect the power cord to the mains.
The heater offers three operation modes:
Fan Function
Heating Stage I (low heat output, warm air circulates, approx. 700 W)
Heating Stage II (high heat output, hot air circulates, 1500 W)
1. Switch on the heater by selecting the desired operation mode with the
selector switch (1).
2. The control LED (4) flashes up as soon as the heater is switched on.
3. Press the button PUSH (2), the switched on heater will start an alternating
panning movement to the left and to the right. This way the heat can be
distributed in the room more efficiently during heating.
4. Turn the thermostat switch (3) clockwise to the highest setting. As soon as
the desired room temperature has been reached, turn the thermostat switch
counter clockwise until you notice a click sound. This way the heater will be
switched on and off automatically. The desired room temperature is
maintained.
5. Turn the thermostat switch clockwise in order to reach a higher room
temperature.
6. Turn the thermostat switch counter clockwise, in order to decrease heating
power. The heater will switch on and off at a lower room temperature.
7. Turn the heating stage switch (1) to the O position to switch off the heater.

Anti Tilt Protection

An anti tilt protection switch (5) is located at the bottom of the heater. In case the
heater leans during operation, gets lifted or gets knocked over by accident, the
heater will automatically precautionary switch off. Put it in the upright position
again and the heater will continue heating.
Cleaning and Storing
without heating
7