ZA DU PRE DE LA DAME JEANNE 60128 PLAILLY – France Declare under our sole responsibility that the product Loudspeaker Type ID84 / ID84L Serial number On the product Is in conformity with the provisions of the following directive 2014/35/UE (Low Voltage Directive)
If the system seems to be malfunctioning or damaged, stop using it at once and have it repaired by a NEXO qualified technician. Do not expose the system directly to the sun or to the rain, do not immerse it into fluids, do not place objects filled with liquid on the system.
Locations for hanging on the back. 2 locations for connecting, 1 on the back and a quick connect in the base cover (ID84 only). ID84 versions T & TIS: a directivity switch, located between the NL4 connectors, allows to virtually curve the drivers to achieve 2 vertical directivity patterns: •...
Page 5
Test steadiness of the assembly by pushing in all directions. Assembly on IDS312 Open the trap above IDS312. Place ID84 on IDS312, magnet keeps it in place IMPORTANT Speaker must always be installed on a horizontal surface. Stand height and footprint must be defined to prevent assembly from collapsing.
ID84 / ID84-TIS use 2+/2-. The 1+/1- pins are used by the sub. ID84L and ID84L-TIS use 1+/1-. ID84-I and ID84L-I are equipped with a cable gland M16 (clamping range, Ø 5 to 12 mm), supplied with a fixed cable 2x 1.5 section, length 2m, outside diameter 8mm ±1 mm →...
For the ID84L, the following setups are available: → NARROW: use when next to an ID84 in NARROW mode. → BROAD: use when next to an ID84 in BROAD mode or when not directly attached to an ID84. Preset •...
Page 8
PRESET ID84 + IDS312 2xID84 / ID84 + ID84L ID84 ID84 ArrayEQ HF: +3dB Switch and Set up: Switch and Set up: NARROW or BROAD NARROW or BROAD ID84 ID84L Switch and Set up: Set up identical to ID84. NARROW or BROAD...
Page 9
PRESET 2xID84 + ID84L / 1x ID84 + 2xID84L ID84 ID84 ArrayEQ HF: +1.5dB ArrayEQ HF: +4.5dB Switch and Set up: Switch and Set up: NARROW or BROAD NARROW ID84 ID84L ArrayEQ HF: +1.5dB Switch and Set up : Setup NARROW...
Switch and Set up: NARROW or BROAD ID84L ID84L Set up identical to the ID84 Setup BROAD directly above. CROSSOVER FREQUENCY → 90 Hz: Full range application. → 120 Hz: Use with a NEXO subwoofer, e.g. IDS312. Page 10 / 20 ID84...
All ID84 / ID84L accessories are specifically rated in agreement with structural computations. Never use other accessories – including push-pins – when assembling ID84 / ID84L cabinets than the ones provided by NEXO: NEXO will decline responsibility over the entire ID84 accessory range if any component is purchased from different supplier.
Page 12
Wall mount (up to 25 kg) 0° to -6° vertical and ± 50° horizontal Can be fixed only on the upper hanging point of the ID84. IDT-BAG84: transport bag for 1x ID84 ou ID84L IDT-2CASE84: flight case for 2x (ID84 ou ID84L) + accessories (...
ID 4 rray ad ustin re uency ID 4 rray ad ustin re uency Apply the following array EQ HF on all ID84 (not ID84L) of the assembly: 1x ID84 2x ID84 0x ID84L No adjustment No adjustment 1x ID84L +3dB +1.5dB...
Tightening torque : 1.5Nm Remove the 4 screws and the RJ45 connector. Remove the 4 screws to access the 4-inch driver. Tx15 Remove the HF assembly. Tx20 Tightening torque : 1.0Nm Tightening torque : 1.2Nm Page 14 / 20 ID84...
Page 15
Top cover White 05ID84HFC HF assembly complete Black 05ID84HFC-PW HF assembly complete White 05HPB4-8 BASS DRIVER 4" 8 OHMS 05ID84T-A Grille ID84 Touring Black 05ID84T-APW Grille ID84 Touring White 05ID84I-A Grille ID84-I Install Black 05ID84I-APW Grille ID84-I Install White 05ID84QC...
Page 16
Top cover Black 05ID84COV-PW Top cover White 05HPB4-8 BASS DRIVER 4" 8 OHMS 05ID84LT-A Grille ID84L Touring Black 05ID84LT-APW Grille ID84L Touring White 05ID84LI-A Grille ID84L-I Instal Black 05ID84LI-APW Grille ID84L-I Instal White 05LOGNEXO3 Logo NEXO Page 16 / 20 ID84...
Need help?
Do you have a question about the ID84 and is the answer not in the manual?
Questions and answers