Operation; Spare Parts - Hans Grohe 19200 Assembly Instructions Manual

Assembly
1 Flush through the supply pipes.
2 Place the mixer including the sealing washer in position on the bidet.
3 Slip the slide washer, washer and collar nut over the threaded base and tighten the
collar nut by hand.
4 Tighten screws.
5 Connect the supply pipes to the angle valves; cold right - hot left.
6 Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and cold water supply should be balanced.

Operation

The mixer is actuated by lifting the lever head.
Swivel to the left = hot water, swivel to the right = cold water.
Swivel range of spout ± 20°.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temperature:
Rate of flow:
To adjust the hot water limiter on single lever mixers, please see page 2.
No adjustment is necessary when using a continuous flow water heater.
Hansgrohe single lever mixers can be used together with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at least 1.5 bars.
In this case the flow limiter must be removed (7a).
To simplify installation pressure hoses no. 13098 are available.

Spare parts

1
handle
1.1
screw cover
2
flange
flange chrome plated
3
nut
4
service set
5
seals (5)
6
mixer ball
7
mousseur cpl. (10)
mousseur gold plated
8
handle for pop-up
9
fixation cpl.
6
GB
19091XX
X X
13987XX
13917
13918
13952
13962
13964
13085
9498099
X X
13961
®
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
8 l/min. 3 bar
XX = Colors
- chrome plated
09 chrome/gold plated
40 white/chrome plated
49 white/gold plated
60 black/chrome plated
69 black/gold plated
6