Table of Contents
Advertisement
Quick Reference Guide
Solution 6+6
Quick Start
The following steps will enable you to use the
factory. The default settings allow the panel to communicate in Contact ID format.
1.
Connect AC plug pack to the control panel.
2.
Check the operation of the red overload LED (LD1) on the PCB. In normal operation the LED will not
illuminate. The MAINS indicator will remain on, as will the AWAY indicator. The unit is now in the
armed state.
3.
Enter the default Master Code
extinguish. The panel is now in the disarmed state. Installer's Programming Mode can now be accessed.
4.
The back-up battery should now be connected.
5.
Enter the factory default Installer Code
AWAY indicators will now flash simultaneously.
6.
Enter the Primary Telephone Number followed by the Secondary Telephone Numbers and the Subscriber
ID Number.
7.
Set the time for the test reports if this option is required. Any other programming changes required can
also be made, otherwise the factory programming default settings will be used.
960
8.
Enter command
control panel will return to the disarmed state and is now ready for use.
9.
Use the Master Code to set the date and time.
How To Set The New Date and Time
1.
Enter your
Three beeps will be heard and the
2.
Enter the day, month, year, hour and minute using the (DD, MM, YY, HH, MM) format.
3.
Press the
Two beeps will be heard and the
Zone Default Settings
The zone default settings are as listed in the table below.
Note:
The example given in this quick reference guide is a simplified description of how to configure
the panel. This system offers many other programmable features, which are described in detail
in the
Solution 6+6
Solution 6+6
2580
followed by the
1234
followed by the
6
followed by
and the
and
STAY
button when finished.
and
STAY
Zone No
Delay-1
1
2, 3, 4 & 5
Handover
6
24 Hour
Table 2: Zone Default Settings
Installation Manual (MA600I).
Bosch Security Systems Pty Limited
panel with the default values as set in the
button. The AWAY indicator will
followed by the
button to exit Installer's Programming Mode. The
button.
indicators will begin to flash.
AWAY
indicators will extinguish.
AWAY
Zone Type
button. The STAY and
SOL 6+6 QUICK REF GUIDE.DOC
Page 5
Advertisement
Table of Contents
