Operating From The Remote Control; Using The Remote Control - DeLonghi EL Series Instructions For Use Manual

poor insulation, too many people, high heat in the room,
strong exposure to the sun, etc...) this device may not be
able to reach the best comfort level.
SELECT THE TEMPERATURE SCALE

OPERATING FROM THE REMOTE CONTROL

INSERTING OR REPLACING THE BATTERIES
• Remove the cover on the rear of the remote control;
• Insert or replace the batteries with two new LR03 "AAA"
1.5V batteries, inserting them correctly (see the directions
inside the battery compartment);
• Replace the cover.
Please note: If the remote control unit is replaced or discarded,
the batteries must be removed and disposed of in accordance
with current legislation as they are harmful to the environment.
Do not mix old and new batteries. Do not mix alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries. Do
not dispose of batteries in fire. Batteries may explode or leak.
If the remote control is not be used for a certain length of time,
remove the batteries.

USING THE REMOTE CONTROL

Point the remote control at the receiver A5 on the air con-
•
ditioner. The remote control must be no more than 16ft/5
meters away from the appliance (without obstacles be-
tween the remote control and the receiver).
• The remote control must be handled with care. Do not drop
it or expose it to direct sunlight or sources of heat.
Please note: The remote control can be safely stored in the ap-
propriate compartment A6.
The temperature can be displayed
in °C or °F.
To change the temperature unit of
measure touch both the increase/
decrease keys and
10 seconds.
max 16ft/5 meters
DESCRIPTION OF THE REMOTE CONTROL
D1) ON/STAND-BY button
D2) Air flow selection button
D3) ECO REAL FEEL button
D4) Timer button
D5) MODE button
D6-D7) Decrease/ Increase button
for about D
D3
D6
D4
TURNING THE APPLIANCE ON/OFF
• Plug into the outlet.
• Press the
turned on, the air conditioner starts operating in the same
mode as when it was turned off) .
To switch the appliance off, press button D1
•
Note: Never switch the appliance off by removing the plug.
Always switch it off by pushing the
few minutes before removing the plug. Only in this way will the
appliance be able to perform its standard checks.
SELECTING THE OPERATING MODES
Most of the commands available on the remote control corre-
spond to those on the appliance control panel A2.
SELECTING THE TEMPERATURES
In air conditioning and heating modes, press increase/decrease
keys to select the desired temperature.
SELECTING THE AIR FLOW
In air conditioning and fan modes, press air flow selection but-
ton on remote control to select the desired air flow. The air flow
available are:
11
D1
D5
D7
D2
button D1 to turn the appliance on (when
Minimum air flow: when maximum quiet
operation is desired.
Medium air flow: when the noise level needs to
be low but with a good comfort level.
Maximum air flow: for maximum performance.
.
button and waiting a