Camera Set-Up; Camera Menu Navigation - Bosch NDN-498V03-21P Installation And Operation Manual

38 en | Camera set-up
6

Camera set-up

The camera normally provides an optimal picture without the
need for further adjustments. Configuration of the camera is
carried out remotely via the network using a web browser.
However, the camera also has a set-up menu in which basic
installation settings (lens wizard, IP address) can be accessed.
To view this menu, connect a monitor to the composite video
output of the camera.
6.1

Camera menu navigation

Five keys are used for navigating through menu system.
Figure 6.1 Navigation
–
–
–
–
–
Some menus automatically close after about two minutes; other
menus have to be closed manually.
AR18-10-B006 | v1.1 | 2010.06
To open the install menu and enable the analog video
output, press and hold the center key for approximately
two seconds. This turns off the IP video stream.
Use the up or down keys to scroll through a menu.
Use the left or right keys to move through options or to set
parameters.
When in a menu, quickly double-press the menu/select key
to restore the selected item to its factory default.
To close all menus at once hold down the menu/select key
until the menu display disappears or continually select the
Exit item. (This turns the IP video stream back on.)
Installation and Operation Manual
Up key
Menu/Select key (center)
Right key
Down key
Left key
FlexiDome2X IP Camera
Bosch Security Systems