Maintenance; Testing The Network Connection; Repairs; Transfer And Disposal - Bosch NDN-498V03-21P Installation And Operation Manual

FlexiDome2X IP Camera
12

Maintenance

12.1

Testing the network connection

The ping command can be used to check the connection
between two IP addresses. This allows testing whether a device
is active in the network.
1.
2.
If the device is found, the response appears as " Reply from ... ",
followed by the number of bytes sent and the transmission time
in milliseconds. Otherwise, the device cannot be accessed via
the network. This might be because:
–
–
12.2

Repairs

CAUTION!
Never open the casing of the unit. The unit does not contain any
user serviceable parts. Ensure that all maintenance or repair
work is performed only by qualified personnel (electrical
engineering or network technology specialists). In case of
doubt, contact your dealer's technical service center.
12.2.1

Transfer and disposal

The camera should only be passed on together with this
installation guide. The unit contains environmentally hazardous
materials that must be disposed of according to law. Defective
or superfluous devices and parts should be disposed of
professionally or taken to your local collection point for
hazardous materials.
Bosch Security Systems
Open the DOS command prompt.
Type ping followed by the IP address of the device.
The device is not properly connected to the network.
Check the cable connections in this case.
The device is not correctly integrated into the network.
Check the IP address, subnet mask, and gateway address.
Installation and Operation Manual
Maintenance | en 123
AR18-10-B006 | v1.1 | 2010.06