Enhance - Bosch NDN-498V03-21P Installation And Operation Manual

FlexiDome2X IP Camera
A low (negative) value means that the camera switches to
monochrome at a lower light level. A high (positive) value
means that the camera switches to monochrome at a higher
light level.
Priority
In Auto switching mode, set the camera priority to either:
–
–
The camera recognizes IR-illuminated scenes to prevent
unwanted switching to color mode.
IR contrast
There are two modes for IR contrast:
–
–
Color burst
–
–
9.6.5

Enhance

Dynamic engine
–
–
–
Bosch Security Systems
Color: the camera gives color pictures as long as the light
level permits.
Motion: the camera gives sharp images without motion
blur as long as the light level permits (it switches to
monochrome earlier than it would with Color priority).
Enhanced: the camera optimizes contrast in applications
with high IR illumination levels. Select this mode for IR
(730 to 940 nm) light sources and for scenes with grass
and green foliage.
Normal: the camera optimizes contrast in mono
applications with visible light illumination.
Off: the color burst in the video signal is switched Off in
monochrome mode.
On: the color burst remains active even in monochrome
mode (required by some DVRs and IP encoders).
Off: turns off all automatic scene detail and enhancements
(only recommendedfor testing).
XF Dynamic: extra internal processing is enabled for low-
light applications (traffic, etc.).
2X Dynamic: 2X Dynamic adds dual sensor exposure to the
XF Dynamic features. In harsh lighting conditions pixels
Installation and Operation Manual
Advanced Mode | en
AR18-10-B006 | v1.1 | 2010.06
73