Advanced - Bosch NDN-498V03-21P Installation And Operation Manual

FlexiDome2X IP Camera
9.10.2

Advanced

The settings on this page are used to set advanced settings the
network. Some changes only take effect after a reboot. In this
case Set changes to Set and Reboot.
1.
2.
The device is rebooted and the changed settings are activated.
SNMP
The camera supports the SNMP V2 (Simple Network
Management Protocol) for managing and monitoring network
components, and can send SNMP messages (traps) to IP
addresses. It supports SNMP MIB II in the unified code.
If On is selected for the SNMP parameter and a SNMP host
address is not entered, the device does not send the traps
automatically and will only reply to SNMP requests. If one or
two SNMP host addresses are entered, SNMP traps are sent
automatically. Select Off to deactivate the SNMP function.
1. SNMP host address / 2. SNMP host address
To send SNMP traps automatically, enter the IP addresses of
one or two target devices here.
SNMP traps
To choose which traps are sent:
1.
2.
3.
Authentication (802.1x)
To configure Radius server authentication, connect the camera
directly to a computer using a network cable. If a Radius server
controls access rights over the network, select On to activate
authentication to communicate with the device.
1.
2.
Bosch Security Systems
Make the desired changes.
Click Set and Reboot.
Click Select. A dialog box appears.
Click the check boxes of the appropriate traps.
Click Set to close the window and send all of the checked
traps.
Enter the user name that the Radius server uses for the
camera in the Identity field.
Enter the Password that the Radius server expects from
the camera.
Installation and Operation Manual
Advanced Mode | en 107
AR18-10-B006 | v1.1 | 2010.06