802.1X - Asus GigaX1116i+ User Manual

4.3.10 802.1X

Users can change the 802.1X configuration in the following fields:
• Mode: Enable or disable 802.1X process for the switch.
• RADIUS IP: Set or show RADIUS server IP address.
• RADIUS UDP Port: Set up UDP Port for the external RADIUS server.
• RADIUS Secret: Set or show the secret shared with the RADIUS server.
• Admin State: Set or show the configured 802.1X state for the port.
Auto: Behavior of the port is controlled by 802.1X protocol.
Force Authorized: Traffic from all hosts to the port is allowed to pass.
Force Unauthorized: Port is blocked and no traffic can go through.
• Port State: Show the port real-time state. (802.1X Disabled, Link Down,
Unauthorized, or Authorized)
• Re-authenticate: Refresh (restart) 802.1X authentication process for the
port.
• Force Reinitialize: Reinitialize the port.
• Statistics: Click to show the Authenticator counters, Backend Authenticator
counters, dot1x MIB counters, and Last Supplicant identity of the port.
• Re-authenticate All: Refresh (restart) 802.1X authentication process for all
ports.
• Force Reinitialize All: Reinitialize all ports.
Click on the "Parameters" button to change 802.1X parametes in the following
field:
• Reauthentication Enabled: Enable or disable reauthentication. Once
enabled, the switch will try to authenticate the port user again in a predefined
period.
• Reauthentication Period: If reauthentication is enabled, this is the time
period to re-send authentication request to the port user. Number is between
1 - 3600.
• EAP timeout: Number is between 1 - 255.
Click on the Apply button to make the configuration effective, or the Refresh
button to refresh the setting to current value as shown in Figure 23. The next
page for statistics is shown in Figure 24. The third page for parameter is shown
in Figure 25.
GigaX Series L2 Smart Plus Switch User Manual
25