Quick Start Guide; Part 1 - Installing The Hardware; Installing The Switch On A Flat Surface; Mounting The Switch On A Rack - Asus GigaX1116i+ User Manual

GigaX Series L2 Smart Plus Switch User Manual
3

Quick start guide

This section provides the basic instructions to set up the GigaX1116i+/
GigaX1124i+ environment. Refer also to the GigaX1116i+/ GigaX1124i+
Installation Guide.
Part 1 shows you how to install the switch on a flat surface or on a rack.
Part 2 provides instructions to set up the hardware.
Part 3 shows you how to configure basic settings on the switch.
Obtain the following information from your network administrator before
proceeding:
IP address for the switch
Default gateway for the network
Network mask for this network
3.1 Part 1 — Installing the hardware
Connect the device to the power outlet, and your computer or network.
Figure 5 illustrates the hardware connections.
3.1.1 Installing the switch on a flat surface
The switch should be installed on a level surface that can support the weight
of the switches and their accessories. Attach four rubber pads on the marked
location on the bottom of the switch.

3.1.2 Mounting the switch on a rack

1. Attach brackets to each side of the switch and make the posts insert to the
switch.
2. Insert and tighten two screws to securely attach the bracket to the rack on
each side.
3.2 Part 2 — Setting up the switch
Connect the device to the power outlet, and your computer or network. See
Figure 5.
6