Crosley C100BT Instruction Manual page 6

English
Turntable Platter and Belt Setup
1. Install the drive belt over the inner ring under the platter and make sure it won't fall
off during the setup.
2. Place the platter through the turntable spindle, then rotate the platter until you see
the drive motor pulley through the window at the top right corner.
3. Carefully grab the drive belt and put it around the slot of motor pulley.
Phono/Line Switch
For increased flexibility of use, this unit has a built-in stereo phono pre-amplifier. If you
prefer to use the phono input of your stereo system or your standalone phono pre-
amplifier, set the Phono/Line switch to the PHONO position. Otherwise, please set it to
LINE position and make connection to the AUX input or other high-level input on your
stereo system.
Stereo System Connection
RCA Jacks
• The RCA Jacks of this unit are shared as both the Phono output jacks and the Line
output jacks. They are determined by the Phono/Line Switch.
• When used as a line output, the jacks output analog line-level signals and could be
connected directly with a pair of active speakers or the appropriate input of your
stereo system. When used as a Phono output, they should be connected to the
phono pre-amp or the phono input of the stereo system.
• The Red plug connects with the Right channel and the White plug connects with
the Left channel.
Note:
− If the Phono/Line switch is set at LINE position but RCA jacks connected to the stereo
system's phono input, the sound might be distorted due to input overload and could
damage your stereo system.
− If the Phono/Line switch is set at PHONO position but RCA jack connected to the stereo
system's line input, the volume will be very low due to lacking signal pre-amplification.
− RCA Jack is not designed to be connected directly to the passive/unpowered speakers
and if it does, the volume will be very low.
6