Remote Kit Installation (Optional) - HYT TM-800 Service Manual

Remote Kit Installation (Optional)

The remote kit is optional, the steps of installation as follow:
1. Lift the tab on the bottom of transceiver, and then pull the panel away from the transceiver.
2. Remove the connector that binds the display unit to the TX-RX unit.
3. As shown in the below figure, make sure that the rubber seal is placed above the cable, then plug
the 11-pin connector into the rear panel socket.
4. As shown in the above figture, affix the ground wire to the front panel chassis with the supplied
screw.
5. Choose the remote wire position (right side or left side), then place the seal within the guide rail.
Attach and secure the cover using the 4 binding screws.
6. Plug the 11-pin connector (from the front panel) to the PCB of Display unit socket, as shown in the
below figure. Push the 11-pin connector (from the front panel) into the chassis so that the 6 tabs on
top and bottom are securely fixed.
111
TM-800 SERVICE MANUAL