Dinrail Assembly - CAMDEN CV-603 Installation Instructions Manual

CV-603 MPROXBLE CONTROLLER / CV-603PS-K1 MPROXBLE CONTROLLER CABINET KIT
I NSTA L L AT I O N I NS T RUCT IONS
6. CV-603PS-K1 CABINET ASSEMBL
DIN Rail
DIN Rail
BLE Base
MProxBLE ASSEMBLY AND
BLE Base and Dinrail ASSEMBLY
BLE Base
1. Take the bottom of the BLE base

DINRAIL ASSEMBLY

and hook it onto the bottom of the DIN
rail. Then take the top part with the red
1. Take the top of the
clip and push it onto the rail until it snaps
MProxBLE base and hook it
into place.
onto the top of the DIN rail.
2.
Then take the bottom part with
to desired location/spacing from
the red clip and push it onto
DIN Rail
Component A
the rail until it snaps into place.
BLE Base
2. Slide the component along
the rail to desired location/
spacing from component A.
DIN Rail
Controller
BLE Base
Power Supply
Page 10 of 20
Battery
Battery
BLE Base and Dinrail ASSEMBLY
BLE Base and Dinrail ASSEMBLY 1. Take the bottom of the BLE base
1. Take the bottom of the BLE base and hook it onto the bottom of the DIN
and hook it onto the bottom of the DIN rail. Then take the top part with the red
rail. Then take the top part with the red clip and push it onto the rail until it snaps
Optional 12 volt, 4AH battery
clip and push it onto the rail until it snaps into place.
Battery
provided by others.
into place.
2.
2. to desired location/spacing from
to desired location/spacing from Component A
Component A
Battery
BLE Base and Dinrail ASSEMBLY
1. Take the bottom of the BLE base
and hook it onto the bottom of the DIN
rail. Then take the top part with the red
clip and push it onto the rail until it snaps
into place.
2.
to desired location/spacing from
Component A
Power supply ASSEMBLY
1. Take the Snap track, align the 2 square holes
Snaptrack
with the mounting holes on the cabine base.
2. Take the 2 screws and place them through the
holes from the back of the cabinet. Place the washer
over the snaptrack and over the screws. Screw the
nuts onto the screw, securing the snaptrack is in
Snaptrack
Power Supply
Power Supply
Snaptrack
Power Supply
Power Supply ASSEMBLY
1. Take the Snap track, align
the 2 square holes with
the mounting holes on the
cabine base.
2. Take the 2 screws and
Power Supply
place them through the
holes from the back of the
cabinet. Place the washer
over the snaptrack and over
the screws. Screw the nuts
onto the screw, securing the
snaptrack is in place.
3. Push the power supply
onto the top of the
snaptrack, into the grooves
allowing the snaptrack to
hook onto the power supply.
Power sup
Power supply A 1. Take t
Snaptrack
1. Take the Sn with the mo
with the mountin
2. Take t
2. Take the 2 holes from
holes from the b over the sn
over the snaptra nuts onto t
nuts onto the sc place.
place.
3. Push
snaptrack,
3. Push the p
Power supply ASSE
snaptrack, into t hook onto
1. Take the Snap t
hook onto the p
with the mounting ho
2. Take the 2 scre
holes from the back
over the snaptrack a
nuts onto the screw,
place.
3. Push the power
snaptrack, into the g
hook onto the power
Power s
1. Tak
Snaptrack
with the
2. Tak
holes fr
over the
nuts on
place.
3. Pu
snaptra
hook on