Brother MFC MFC-9120CN User Manual page 159

Error Message
Replace Fuser
Replace PF Kit
Replace Toner
Replace WT Box
Scan Unable XX
(XX=Error Code)
Short paper
Size mismatch
Small paper
Toner Low
Too Many Files
(MFC-9320CW only)
Unusable Device
(MFC-9320CW only)
WT Box End Soon
1
(X) shows the toner cartridge or drum unit colour that is near the end of its life. (K)=Black, (Y)=Yellow, (M)=Magenta,
(C)=Cyan.
Cause
It is time to replace the fuser unit. Call your Brother dealer to replace the fuser
It is time to replace the paper
feeding kit.
The toner cartridge is at the end
of its life.
It is time to replace the waste
toner box.
The machine has a mechanical
problem.
The paper size detected is
shorter than the paper size
defined in the print job and the
paper size being used requires
the back cover to be open.
The paper in the tray is not the
correct size.
The paper size defined in the
printer driver requires the back
cover to be open.
The toner cartridge is near the
end of its life.
There are too many files stored
on the USB Flash memory drive.
An incompatible or broken device
has been connected to the USB
direct interface.
The waste toner box is almost full. Buy a new waste toner box before you get a
Troubleshooting and routine maintenance
Action
unit.
Call your Brother dealer to replace the
PF Kit.
Replace the toner cartridge for the colour
indicated on the LCD. (See Replacing a
Toner cartridge on page 168.)
Replace the waste toner box. (See
Replacing the waste toner box on page 181.)
Disconnect the machine from the power
for several minutes, then reconnect it.
(The machine can be turned off for up to
60 hours without losing faxes stored in
the memory. See Transferring your faxes
or Fax Journal report on page 148.)
If the problem continues, call Brother
Customer Service.
Open the back cover (back output tray) and
remove any printed pages. Leave the back
cover open and press Mono Start or
Colour Start.
Load the correct size of paper in the tray and
" "
set the Paper Size (Menu, 1, 2, 2 (See
Paper Size on page 24)).
Open the back cover (back output tray) and
press Mono Start or Colour Start. (See
Printing on thick paper, labels, envelopes or
small paper on page 13)
Buy a new toner cartridge for the colour that
is indicated on the LCD before you get a
Replace Toner message.
Reduce the number of files stored on the
USB Flash memory drive.
Remove the USB Flash memory drive from
the USB direct interface.
Replace WT Box message.
C
147