Canon Oce VarioPrint 6000+ Series Operation Manual page 181

Area
4.
Close K1, K2, K4 and K5.
5.
Close the front door of the puncher.
Description
Check the bypass:
• Lift lever K1.
• Check for jammed media in the bypass, the entrance guide (1) and
the diverter (2).
Check the downward paper path:
• Open latch K2.
• Check for jammed media.
• If necessary, turn knob K2 anti-clockwise until the paper falls down.
Check the die set:
• Turn knob K3/K7 clockwise until the puncher is in the home position.
Then the black lines on the knob (3) and the frame are aligned.
• Slide the die set out.
• Check for jammed media.
• Put the die set back.
Check the bottom of the paper path:
• Press lever K4 inward and lower the U-channel.
• Check for jammed media.
• If necessary, turn knob K4 until the paper falls down.
Check the upward paper path:
• Open latch K5.
• Check for jammed media.
• If necessary, turn knob K5 clockwise until the paper falls down.
Chapter 10 - Optional finishers and other devices
Troubleshooting
181