Motor Brush Replacement - Blue-White ProSeries CHEM-PRO C2F Series Manual

Page 18
12.3

Motor Brush Replacement

Brushes wear differently on each side of motor. It is recommended to replace both brushes at the same time.
Curvature of
Brush to match
Curvature of Motor
Step 1
Remove 4 black rubber bumpers from bottom frame.
Step 2
Remove 6 screws from underneath side of bottom frame.
Step 4
Lift off top cover from bottom frame carefully. Place top cover close to bottom frame.
Please Note: Wires connecting top and bottom may become unplugged if pulled too far apart.
Step 5
Unscrew and remove brush caps by turning counter-clockwise.
Step 6
Remove used brushes and discard properly.
Step 7
Insert new brushes. Be sure to install brushes to that curvature of brush is concentric to curvature of motor.
Please note: One extra set of brushes are provided inside frame.
Top Cover
Brush
®
CHEM-PRO C2F/C3F
Brush Cap (2)
Replacement Brush Kit P/N:
C2/C3 72000-378
Extra set
of brushes
Bottom
Frame
Screws (6)
Rubber
Bumper (4)