Cleaning The Pre-Filter - Honeywell HFD-110 Important Safety Instructions Manual

HFD-110_OM.qxd 5/29/08
REMOVING / CLEANING THE IFD
Resetting the Filter Clean Indicator
After cleaning the IFD
• Once the IFD ™ filter has been checked and cleaned, the filter monitor will need to be reset.
• With the air purifier unit powered on, press and hold the filter reset button for approximately 10
seconds or until the LCD display is clear.

CLEANING THE PRE-FILTER

To remove the pre-filter:
Press the top tab to release the pre-fi lter from the filter
assembly (Fig. 10).
To clean the pre-filter:
The particle pre-filter helps pick-up large airborne particles
that enter the filter. The pre-filter can be removed and
rinsed by hand under warm water (Fig. 10). Let the pre-filter
dry completely before inserting it back into the unit.
REPLACING THE ULTRAVIOLET (UV) LAMPS
The UV Reset LED light will illuminate when it is time to
replace the dual UV bulbs.
• Be sure to turn off and unplug your air purifier.
• Press the Filter Release button and remove the filter
assembly.
• The UV bulb housing is on the left and has a finger grip
for ease of removal (Fig. 12). Gently remove the UV bulb
housing.
• Turn the tab towards the unlock symbol ( ) (Fig 13).
• Gently grasp the top of the tab and pull the bulb cartridge straight out of the UV
socket. Do not touch the bulb directly with your hands.
• Do the same for the bottom tab and pull the bulb cartridge out of the UV socket.
• Replace the top and lower UV bulb sockets.
• The bulb cartridge will only fit one way; if it does not fit, turn the bulb cartridge
the other way (with the arrow pointing to the center of the unit) and insert.
• Push down gently so that the bulb cartridge engages with the unit. Turn arrow to the lock position ( ).
• Discard old UV bulb cartridge(s) only at household hazardous waste collection sites.
• Place UV bulb housing back in air purifier housing and then insert IFD
• Press UV reset button (Fig. 14).
NOTE: Bulb and bulb housing are not intended for use with any other product or purpose.
9:42 AM Page 5
™ FILTER (
CONTINUED
™ filter, you need to reset the filter monitor.
)
Fig. 10
Fig. 12
™ filter assembly.
Fig. 11
Fig. 13
Fig. 14
5