Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Ross Vision 4800DR-332-02
Summary of Contents for Ross Vision 4800DR-332-02
- Page 1 Ross Video Limited Extended Tallies Installation Guide...
- Page 2 Notice The material in this guide is furnished for informational use only. It is subject to change without notice and should not be construed as commitment by Ross Video Limited. Ross Video Limited assumes no responsibility or liability for errors or inaccuracies that may appear in this guide.
- Page 3 To avoid the potential release of those substances into the environment and to diminish the need for the extraction of natural resources, Ross Video encourages you to use the appropriate take-back systems. These systems will reuse or recycle most of the materials from your end-of-life equipment in an environmentally friendly and health conscious manner.
-
Page 4: Package Contents
Package Contents The contents of a single Extended Tallies Upgrade kit is listed below. If any items are missing, or damaged, contact Ross Video Technical Support. Part# Item 4800AR-105 Panel Tallies Board 4800CR-324 Tally Power Cable 727-020R Tally Interface Cable (Green, CAT5e) - Page 5 Extended Tallies Installation To install the new tally board, you must remove the blank plate from the slot where you want to install the tally board, install the tally board, and then connect the power and control cables. The maximum parallel tallies supported by each control panel is as follows: Vision 1 —...
- Page 6 Remove the 4 Retaining Screws from the blank plate where you want to install the Tally Board and remove the blank plate from the slot. Keep the Retaining Screws in a safe place as you will need them to install the Tally Board. Align the Tally Board with the Tally Ports out the hole in the back of the control panel tub, and the 4 Retaining Screw Holes with the standoffs on the bottom of the tub (Figure 2).
- Page 7 To Previous Tally Board To Next Tally Board Figure 4 Tally Board — Tally Power Connectors 10. Close the control panel lid and reconnect the Main and Redundant (if installed) power to the control panel. 11. Power up the control panel. This completes the procedure for installing an additional Tally Board.
- Page 8 Extended Tallies Setup With the additional Tally Boards installed, the corresponding tallies are available for use. Each Tally Board provides 36 tallies as standard, with 18 tallies per port (Figure 5). Tallies 1-18 Tallies 37-54 Tallies 73-90 Tallies 109-126 Tallies 19-36 Tallies 55-72 Tallies 91-108 Tallies 127-144...
- Page 9 Notes Extended Tallies Setup • 9...
- Page 10 Notes 10 • Extended Tallies Setup...
- Page 11 Notes Extended Tallies Setup • 11...
- Page 12 613 • 349 • 0006 613 • 652 • 4425 General Information solutions@rossvideo.com E-MAIL Technical Support techsupport@rossvideo.com 8 John Street, Ross Video Limited Iroquois, Ontario, Canada K0E 1K0 POSTAL SERVICE P.O. Box 880, Ross Video Incorporated Ogdensburg, New York, USA...
Need help?
Do you have a question about the Vision 4800DR-332-02 and is the answer not in the manual?
Questions and answers