MACDEV DROID Owner's Manual page 27

Symptom
Your Droid is chopping
paintballs
Your Droid will not fire
Your Droid fires high on
the first shot or inconsis-
tently
Your Droid fires low on
the first shot
Possible Cause
Beam sensor is turned off
Beam sensor is dirty or blocked
Loader is set on a force setting
too high for your paintballs
Detents are missing or incorrectly
installed
The trigger is set up incorrectly
The beam sensor is on, and there
are no paintballs loaded
Microswitch is not working
The solenoid is not plugged in
Creeping inline regulator
Sticking drive train
Solution
Always play with the beam sensor en-
abled
Clean the breach, bolt and sensor.
Some force fed loaders can apply enough
force to break a fragile paintball. If this is
the case, consult your loader manual to
reduce the force setting.
Replace or re-install your detents.
Ensure that the trigger actuates the mi-
croswitch by adjusting the actuator screw.
Load some paintballs
Ensure it is plugged into the correct posi-
tion, or replace.
Plug the solenoid into the board.
Clean and lubricate the inline regulator,
ensure that the seat and piston are in
good condition.
Clean and relubricate the drive train. If
you continue to have problems:
-increase the dwell by 1-2 ms
-increase the ABS parameter on your
board
26