MACDEV DROID Owner's Manual page 14

Flickering White Eye Mode
Flickering Green Bolt Tracking Delay (ms)
Flickering Yellow Test Mode Dwell (ms)
Setting the Debounce - LED Colour Blue
The debounce setting of your marker is used to control the amount of "bounce" in your trigger. A very
low debounce setting will result in a lot of bounce. In some tournaments or fields, it will be necessary to
reduce the amount of bounce by increasing the debounce setting. Always increase the debounce slowly,
because settings higher than 15 will result in your marker feeling unresponsive.
Setting the Dwell - LED Colour Red
The dwell setting controls the amount of time that your solenoid is held open. A very low dwell will result
in very poor performance from your Droid, whilst a very high value will result in a very slow maximum rate
of fire. For best results, you should only operate your Droid dwell in the range of 12-16ms.
Setting the Fire Mode - LED Colour White
Your Droid is equipped with 12 different fire modes. These fire modes will allow you to use your Droid in
many different situations - tournament play, recreational and scenario. Always follow the rules and local
regulations when selecting your fire mode. The available fire modes are given below:
1 Uncapped semi
2 Capped semi
3 PSP Auto Response
4 PSP/Millenium mild ramp
5 PSP/Millenium max ramp
6 PSP Z-Burst
7 NXL Full Auto
8 Auto Response
9 Mild ramp
10 Max ramp
11 3 shot burst
12 Full auto
2 (forced
shot)
10
2
NOTE: SOME VERSIONS MAY
HAVE SOME MODES REMOVED
TO COMPLY WITH LOCAL LAWS.
FOR EXAMPLE, ALL MARKERS
SOLD IN AUSTRALIA OFFER
ONLY SEMI AUTO MODES.