MACDEV DROID Owner's Manual page 11

USING YOUR DROID
To get the most out of your Droid, make sure that you follow the instructions in
this section to ensure that the marker is adjusted correctly.
Adjusting the velocity
The velocity of the Droid is adjusted via an adjustment screw on your inline
regulator. To increase velocity, use a 3/32" allen key to turn the adjustment
screw anti clockwise. Always adjust your Droid gently and using a chrono-
graph.
DO NOT ADJUST YOUR VELOCITY ABOVE 300FPS, AND ALWAYS
OBEY LOCAL LAWS AND REQUIREMENTS.
Adjusting the trigger
Your Droid trigger has three adjustment screws, they are located in the front
face of the trigger in the following order from top to bottom:
- Pull tension
- Switch actuation point
- Pull length
You may easily adjust these three screws to personalise the feel of your trigger.
CAUTION! WHEN ADJUSTING THE SWITCH ACTUATION SCREW,
MAKE CERTAIN THAT YOU DO NOT ADJUST THE SCREW IN TOO
FAR, AS THIS MAY RESULT IN DAMAGE TO YOUR MICROSWITCH.
Replacing the battery
Lay your Droid on a table with the barrel pointing to your left and the feed tube
pointing away from you.
Contents
Know your Droid
Quick Setup
Using your Droid
Advanced Setup
Maintenance
Parts List
Troubleshooting
of velocity adjustment
10
Pic