MACDEV CLONE Owner's Manual page 6

Using a loader with your Clone
Your Clone marker can operate using any commercially available loader.
The software and beam sensor will compensate for the speed of the hopper,
ensuring that the marker fires as quickly as the loader allows.
All Clone markers are equipped with a cam lever clamping feed tube. This
system allows the easy installation and removal of your loader. You will need
to adjust the feed tube to suit the loader that you have.
Installing a loader onto your Clone
Open the cam lever as shown. This should allow your loader neck to fit into
the feed tube as shown. If your loader does not fit into the feed tube, then
you may have to loosen the adjustment screw slightly. Once your loader is
pushed all the way down into the feed tube, close the cam lever. If your loader
is loose, you may now tighten the adjustment screw (by turning clockwise) to
tighten the loader in place.
DO NOT OVER TIGHTEN YOUR FEED CLAMP! OVERTIGHTENING
MAY RESULT IN DAMAGE TO YOUR LOADER OR CLAMP.
Removing your loader
Open the clamp by swinging the lever on its hinge. This will loosen the loader and allow you to remove it
easily. If it does not remove easily, then it means that you have the clamp adjustment screw overtightened.
USING YOUR CLONE
To get the most out of your marker, make sure that you follow the instructions
in this section to ensure that the marker is adjusted correctly.
Adjusting the velocity
Open clamp and
The velocity of the Clone is adjusted via an adjustment screw on the bot-
push loader in
tom your inline regulator. To increase velocity, use a 1/8" allen key to turn the
adjustment screw anti clockwise. Always adjust your velocity gently and use a
chronograph.
DO NOT ADJUST YOUR VELOCITY ABOVE 300FPS, AND ALWAYS
OBEY LOCAL LAWS AND REQUIREMENTS.
Adjusting the trigger
Close clamp
Your trigger has three adjustment screws, they are located in the front face of
firmly
the trigger in the following order from top to bottom:
- Pull tension
- Switch actuation point
- Pull length
You may easily adjust these three screws to personalise the feel of your trigger.
CAUTION! WHEN ADJUSTING THE SWITCH ACTUATION SCREW,
MAKE CERTAIN THAT YOU DO NOT ADJUST THE SCREW IN TOO
FAR, AS THIS MAY RESULT IN DAMAGE TO YOUR MICROSWITCH.
Contents
Know your Clone
Quick Setup
Using your Clone
Advanced Setup
Maintenance
Parts List
Troubleshooting
Increase
Velocity
Tension
Actuation
Length
10