Apex™ Barrel; E-Grip - BT DELTA ELITE Operator's Manual

Specifications:
Power requirements: 4AA batteries (not included)
Capacity: 200+ paintballs
Feed Rate: 20bps+
Construction: Nylon
Features:
Auto-Off 1 Hour
Low Battery Indicator
Ultra-Quiet Belt Drive
Tactile Feedback Power Button
Delta Elite Apex™ Barrel
The Apex barrel is the most advanced barrel in
the world. You can adjust the barrel to shoot in
different directions and set it to give you greater
distance than any standard barrel.
Setting the Apex™ Barrel Ramp
1. Start with the Ramp in the OFF position
(toward the back of barrel)
2. Follow all safety and paintball loading instruc-
tion for safe use.
3. Go to your fields shooting range or other approved area.
4. Gradually adjust the Ramp forward until you see the balls start to change there
trajectory. The further you move the Ramp forward; the balls will have higher
degree of curve.
Adjusting Direction of Shots
1. Adjust the Apex front by turning it.
2. Turning it right will give you a right hook
3. Turning it left will give you a left hook
4. Rotating it 180 degrees will give you a drop shot.
5. The standard position will give you a long shot.
Note: It will be necessary to adjust the Ramp setting on the Apex barrel to the paint
you are using. Different brands/types of paintballs will have a slightly different size.
This will affect the amount of curve you get.
Features
1. On/Off capability.
2. Hit previously untouchable targets with new curve feature.
3. Adjustable ramp switch - choose the desired level of the curve.
4. Left hook, right hook, drop shot and long flat trajectory shots with a twist of the
barrel.
5. Easy to dial in targets and change the level of curve.
4

E-Grip

The E-Grip has 3 different firing modes-
Semi-Auto, Ramping and Full-Auto. The
modes are changed by removing the left
side grip and adjusting the dip switches
located in the grip frame. The Delta Elite
comes in Ramping mode from the factory
and the Jumper in the frame must be
removed to lock the firing mode to semi-
auto. The E-Grip has an automatic shut-off
after 1 hour of inactivity.
Note: Always use good name brand batteries. Using other types of batteries will
affect the marker performance.
Adjusting the Sear Height
To adjust the sear height, there is a set
screw in the lower vertical arm of the sear
that contacts the front of the solenoid. If it
is necessary to raise the sear to engage
the rear bolt, insert a 0.50" allen wrench
past the side of trigger and turn the allen
wrench counter clockwise. Make adjust-
ments while the trigger frame is off the
receiver (body) and the marker is
degassed. Look down from the top of
frame to help locate the set screw. Only
turn the allen wrench 1/8 turn at a time and check engagement after each adjust-
ment. Once the sear begins to engage the rear bolt, turn the set screw an additional
half to 1 full turn.