Table of Contents
Advertisement
7.0 User's Guide
7.5 Knife and Die Change
1. The knife head assembly must be held in the down position. Remove the chip drawer. Depress
and hold the foot switch. Insert the hold-down block as shown in the following figure.
2. Switch off the machine and disconnect power from the machine. See Power Lockout Procedure
on page 4.
3. Open the top cover.
4. Lift the plunger by pulling the washer on top of the knife holder, Figure 7, page 14.
5. Insert the spring retainer between the washer and the knife holder.
6. Back off the knife adjustment setscrew to prevent damage to the new knife.
14
Sharp knives! Even used knives are extremely sharp. Severe
lacerations may result from improper handling of knives.
Figure 6 - Knife Hold-Down Block
Figure 7 - Retain the Plunger in the Up Position
Advertisement
Table of Contents
