Table of Contents
Advertisement
7.0 User's Guide
7.2 SCM (Power Model) Operation
1. Switch on the main power. The main power switch is located on the left side of the stand,
underneath the table.
2. Lift the top cover guard and load the stock using the jogging aid. Jog the stock against the side
gauge to line it up. Push and jog it against the back gauge.
3. Depress and hold the foot switch to cut. Release the foot switch after the knife stops moving
down. The knife returns to the up position. The hydraulic motor will shut off.
7.3 MSCM (Manual Model) Operation
1. Load the stock using the jogging aid. Jog the stock against the side gauge to line it up. Push and
jog it against the back gauge.
2. Depress the foot pedal to cut. Let up on the foot pedal after the cut is complete.
7.4 Side and Back Gauge Adjustment
1. Switch off the machine and disconnect power. See Power Lockout Procedure on page 4.
2. Open the top cover.
3. Loosen the side gauge mounting screws and use a straight edge to align it tangent to the radius
on the die. Tighten the mounting screws.
4. Loosen the back gauge mounting screws. Place a square against the side gauge.
5. Adjust the back gauge square to the side gauge and tangent to the radius on the die. Tighten the
mounting screws.
6. Reconnect power to the machine
7.5 Knife and Die Change
1. Open the top cover.
(steps 2 – 7 are for MSCM models ONLY):
2. Place the solid plastic square block under the clamp plunger.
3. Press down and hold the foot pedal.
4. Insert the knife change lock pin into the first (higher) hole in pressure foot guide shaft (Figure 6)
and release the foot pedal.
5. Place the jogging aid under the clamp plunger as shown in Figure 6.
6. Press down and hold the foot pedal.
7. Remove the knife change lock pin from the highest hole and insert it into the lower hole (Figure
6), then release the foot pedal.
(steps 8 – 10 are for SCM models ONLY):
8. Place the jogging aid under the clamp plunger as shown in Figure 6.
9. Switch on power and press down and hold the foot switch.
10. Insert the knife change lock pin into lower hole in pressure foot guide shaft (Figure 6) and release
the foot switch.
12
Keep hands away from the knife and plunger!
Always use the jogging aid while cutting.
Keep hands away from the knife and plunger!
Always use the jogging aid while cutting.
Sharp knives! Even used knives are extremely sharp. Severe
lacerations may result from improper handling of knives.
Advertisement
Table of Contents
