Scm Operation; Mscm Operation (Manual Machine); Side And Back Gauge Adjustment - Challenge SCM Instructions And Parts Manual

7.2 SCM Operation

1. Switch on the main power. The main power switch is located on the left side of the stand,
underneath the table. Both the pump and the table light will switch on.
2. Load the stock using the jogging aid. Jog the stock against the side gauge to line it up. Push and
jog it against the back gauge.
3. Depress and hold the foot switch to cut. Release the foot switch after the knife stops moving
down. The knife returns to the up position.

7.3 MSCM Operation (Manual Machine)

1. Load the stock using the jogging aid. Jog the stock against the side gauge to line it up. Push and
jog it against the back gauge.
2. Depress the foot pedal to cut. Let up on the foot pedal after the cut is complete.

7.4 Side and Back Gauge Adjustment

1. Switch off the machine and disconnect power. See Power Lockout Procedure on page 4.
2. Open the top cover.
3. Loosen the side gauge mounting screws and use a straight edge to align it tangent to the radius
on the die. Tighten the mounting screws.
4. Loosen the back gauge mounting screws. Place a square against the side gauge.
5. Adjust the back gauge square to the side gauge and tangent to the radius on the die. Tighten the
mounting screws.
6. Reconnect power to the machine
Keep hands away from the knife and plunger!
Always use the jogging aid while cutting.
Keep hands away from the knife and plunger!
Always use the jogging aid while cutting.
7.0 User's Guide
13