Table of Contents
Advertisement
7. Remove the die mounting screws and die.
8. Remove the knife mounting screws and knife.
9. Insert the new knife against the adjustment setscrew and install the knife mounting screw. Snug
the screw but do not tighten at this time.
10. Using the knife adjustment setscrew, adjust the knife until the cutting edge is 1/8" above the
surface on which the die mounts.
11. Securely tighten the knife mounting screw.
12. Place the die on its mounting surface on the table and reinstall its mounting screws.
13. Place a piece of tissue paper between the knife and the die to ensure proper clearance.
14. Adjust the die to make perfect contact with all points against the knife. Securely tighten the die
mounting screws.
15. Remove all tools from the table. Remove the plunger retainer.
16. Close the top cover and reconnect power to the machine.
17. Switch on the machine.
18. Depress and hold the foot switch. Carefully remove the knife assembly hold-down block.
19. Release the foot switch.
20. Reinstall the chip drawer.
Figure 8 - Knife and Die Change
(Plunger not shown for clarity)
Figure 9 - Die Adjustment
7.0 User's Guide
15
Advertisement
Table of Contents
