If You Are Having Difficulty With Your Dcp - Brother DCP-8020 User Manual

If you are having difficulty with your DCP

If the copy looks good, the problem is probably not your DCP. Check
the chart below and follow the troubleshooting tips.
DIFFICULTY
Printing
Condensed print and
horizontal streaks or the top
and bottom of sentences are
cut off.
Poor quality print.
Vertical black lines.
Copy Quality Difficulties
Vertical streaks appear in
copies.
Printer Difficulties
The DCP does not print.
The DCP prints unexpectedly
or it prints garbage.
The DCP prints first couple of
pages correctly, then some
pages have text missing.
The DCP cannot print full
pages of a document.
Out of Memory message
occurs.
My headers or footers appear
when I view my document on
the screen but do not appear
when I print them.
14 - 11 TROUBLESHOOTING AND ROUTINE MAINTENANCE
SUGGESTIONS
If the copy looks bad, clean the scanner area. If there is still problem, call
Brother Customer Service at 1-800-284-4329 (in USA), 1-877-BROTHER
(in Canada) or (514) 685-6464 (in Montreal) or your dealer for service.
See Improving the print quality on page 14-14.
Your DCP's primary corona wire for printing may be dirty. Clean your
primary corona wire (see Cleaning the drum unit on page 14-23). If the
problem continues, call Brother Customer Service at
1-800-284-4329 (In USA), 1-877-BROTHER (In Canada) or
(514) 685-6464 (In Montreal).
Sometimes you may see vertical streaks on your copies. Either the
scanner or the primary corona wire for printing is dirty. Clean them both.
(See Cleaning the scanner on page 14-21 and Cleaning the drum unit
on page 14-23.)
Check the following:
• The DCP is plugged in and the power switch is turned On. (See Quick
Setup Guide on page 5.)
• The toner cartridge and drum unit are installed properly. (See
Replacing the drum unit on page 14-30.)
• The interface cable is securely connected between the DCP and
computer. (See Quick Setup Guide.)
• Check to see if LCD is showing an error message. (See Error
messages on page 14-1.)
Reset the DCP or turn it off and then on again. Check the primary
settings in your application software to make sure it is set up to work with
your DCP.
Your computer is not recognizing the printer's input buffer full signal.
Please make sure to connect the DCP cable correctly.
Reduce the printing resolution. Reduce the complexity of your
document and try again. Reduce the graphic quality or the number of
font sizes within your application software.
Most laser printers have a restricted area that will not accept print.
Usually these are the first two lines and last two lines, leaves 62
printable lines. Adjust the top and bottom margins in your document to
allow for this.