Brother DCP-770W Quick Setup Manual page 44

STEP 2
Installing the Driver & Software
5
Enter the SSID you wrote down in step 1 using
a, b keys to choose each letter or number. You
can use the
cursor left and right. For example, to enter the
letter a, press the a key once. To enter the
number 3, hold down the a key until it appears.
The letters appear in this order: lower case,
upper case, numbers and then special letters.
(For more information, see Entering
Text on page 47.)
Press OK when you have entered all the
characters.
6
Press a or b to choose Infrastructure,
then press OK.
7
Use the a, b and OK keys to choose one of the
options below: If your network is configured for
Authentication and Encryption you must match
the settings used for your network.
No Authentication or Encryption: Choose
Open System, press OK then choose None
for Encryption Type? and press OK. Then
press
Go to step 10.
No Authentication with WEP Encryption:
Choose Open System, press OK then use the
a or b to choose WEP for the
Encryption Type? and press OK. Go to
step 8.
Authentication with WEP Encryption:
Choose Shared Key, press OK. Go to step 8.
Authentication with WPA/WPA2-PSK (TKIP
or AES) Encryption: Choose
WPA/WPA2-PSK, press OK. Go to step 9.
8
Press a or b to choose the appropriate key
number and press OK. Enter the WEP key you
wrote down in step 1 using a, b keys to choose
each letter or number. You can use the
and
For example, to enter the letter a, press the a
key once. To enter the number 3, hold down
the a key until it appears.
The letters appear in this order: lower case,
upper case, numbers and then special letters.
(For more information, see Entering
Text on page 47.)
Press OK when you have entered all the
characters, then press
settings. Go to step 10.
42
and keys to move the
to choose Yes to apply your settings.
keys to move the cursor left and right.
Yes to apply your
Most access points and routers can store
more than one key, but they will only use
one at any time for authentication and
encryption.
9
Press a or b to choose TKIP or AES for
Encryption Type? and press OK.
Enter the WPA/WPA2-PSK password you
wrote down in step 1 using a, b keys to choose
each letter or number. You can use the
and keys to move the cursor left and right.
For example, to enter the letter a, press the a
key once. To enter the number 3, hold down
the a key until it appears.
The letters appear in this order: lower case,
upper case, numbers and then special letters.
(For more information, see Entering
Text on page 47.)
Press OK when you have entered all the
characters, then press
settings. Go to step 10.
10
Your machine will now try to connect to your
wireless network using the information you
have entered. If successful, Connected will
appear briefly on the LCD.
If your machine does not successfully connect
to your network, you should repeat steps 2 to 9
to make sure you have entered the correct
information.
If your access point does not have DHCP
enabled you will need to manually configure
the IP address, subnet mask and gateway of
the machine to suit your network. See the
Network User's Guide for details.
Wireless setup is now complete. A four
level indicator on the bottom of your
machine's LCD will show the wireless
signal strength of your access point or
router. To install MFL-Pro Suite, continue
to step 11.
®
Macintosh
Yes to apply your