Print Quality Check; Setting The Lcd Contrast - Brother DCP-770W Quick Setup Manual

STEP 1
Setting Up the Machine
6

Print quality check

1
Make sure A4, Letter or Legal size paper is
loaded in the paper tray.
Press Colour Start.
The machine starts printing the Print Quality
Check Sheet (only during initial ink cartridge
installation).
2
Check the quality of the four colour blocks on
the sheet.
(black/yellow/cyan/magenta)
Note
Avoid touching the printed surface of the paper
immediately after printing, the surface may not be
completely dry and may stain your fingers.
3
The LCD shows:
If all lines are clear and visible, press
(Yes) to finish the quality check.
If you can see missing short lines, press
(No) and go to step 4.
OK
10
Is Quality OK?
Yes Press
No
Press
Poor
4
The LCD asks you if the print quality is OK for
black and colour. Press
Black OK?
Yes
No
Color OK?
Yes
No
After pressing (Yes) or
black and colour, the LCD shows:
Start Cleaning?
Yes
No
5
Press (Yes), the machine will then start
cleaning the colours.
6
After cleaning is finished, press Colour Start.
The machine starts printing the Print Quality
Check Sheet again and goes back to step 2.
7

Setting the LCD Contrast

You can adjust the LCD contrast for a sharper and
more vivid display. If you are having difficulty reading
the LCD, try changing the contrast setting.
1
Press Menu.
2
Press a or b to choose General Setup.
Press OK.
3
Press a or b to choose LCD Settings.
Press OK.
4
Press a or b to choose LCD Contrast.
5
Press or to choose Light, Med or
Dark. Press OK.
6
Press Stop/Exit.
Note
You can also adjust the angle of the LCD display
by lifting it.
(Yes) or (No).
Press
Press
Press
Press
(No) for both
Press
Press