Nokia RH-6 Series Rf Description & Troubleshooting page 59

CCS Technical Documentation
The setup should now look like this:
Select
Tune Base level to –27 dBm.
Adjust DAC Values for Power Level 0 (30 dBm), 11 (8 dBm) and 15 (0 dBm). The Power
levels may differ from in Phoenix mentioned target power levels.
Make sure that the output power for Power Level 0 is equal or lower than 1dB below the
saturation output power. Determine the saturation power by setting the DAC Value to its
maximum. (For example: If the saturation output power is only 30.7dBm, then adjust the
DAC Value for Power Level 0 to 29.7dBm)
Press calculate, check if all levels match the target values, correct if necessary.
Issue 1 10/2003
Company Confidential
TX PA Mode
Copyright © 2003 Nokia Corporation.
Company Confidential
7 - RF Description & Troubleshooting
High
RH-6
Page 59