Gsm1800 Tx Troubleshooting - Nokia RH-6 Series Rf Description & Troubleshooting

RH-6
7 - RF Description & Troubleshooting

GSM1800 TX troubleshooting

Setup for GSM1800 TX troubleshooting
Start the investigations as described in chapter General instructions for TX troubleshoot-
ing "General instructions for TX troubleshooting".
Set operating mode to local mode.
Select
Wait until the RF Controls window pops up.
Select
The setup should now look like this:
Now the measurement equipment should measure the following output signal from the
phone.
P = +20dBm @ 1747.8MHz
out
If this is not the case, then go to the next chapter for finding the fault.
Fault finding chart for GSM1800 transmitter
It is useful to use the TXP signal as trigger-signal It is provided at TXP test point.
Page 24
Company Confidential
Maintenance Testing
Band
Active unit
Operation mode
RX/TX Channel
TX PA Mode
TX Power Level
TX Data Type
Copyright © 2003 Nokia Corporation.
Company Confidential
CCS Technical Documentation
RF Controls
GSM 1800
TX
Burst
700
Free
5
Random
Issue 1 10/2003