Battery Pack And Charger - LawnMaster CLMF4016K Operator's Manual

BATTERY PACK AND CHARGER

BATTERY CHARGING
1. Use only with 40V LawnMaster
the lithium-ion battery used in this tool.
2. Check the power voltage! Battery chargers operate on 120V.
3. The battery is charged between 40°F (4°C) and 100°F (38°C). This ensures an optimum battery service
life.
4. Protect the battery from heat, from continuous exposure to sun and keep away from radiation or other heat
sources. Do not leave the battery in the mower in direct sunlight over long periods.
5. The battery is supplied uncharged. To ensure full capacity of the battery, charge the battery before using
the tool for the first time. The lithium-ion battery can be charged at any time without reducing its service life.
Interrupting the charging procedure does not affect the battery.
6. Always leave it fully charged if kept in the charger for storage.
LED CHARGER STATUS
1. If the battery is not inserted into the charger, a continuous red LED light indicates that the outlet plug is
plugged into an outlet socket and the battery charger is ready for operation.
2. Charging: a flashing green LED on the charger indicates that the battery is charging normally. The LED's
flashing frequency is 1Hz.
3. Charged: continuous green LED on the charger indicates that the battery is ready for use.
4. Technical Issue: a flashing red LED light on the charger indicates that battery pack has a charging
problem or might be defective.
a) One possible condition is the battery temperature is lower than 0°C or the charging current is too high.
As soon as the permitted temperature and the charging current ranges are reached, the battery charger
will automatically switch to charging.
b) If the temperature range and charging current are correct and flashing red LED light continues, then
remove and reinstall the battery pack. If the LED status repeats a second time, try to charge another
identical battery. If the battery charges normally, dispose of the defective battery pack (see Environmental
Safe Battery Disposal section).
c) If the flashing red light continues after installing the second battery, the charger may be defective.
Replace with a new one.
5. A flashing green LED light on the charger (the LED's flashing frequency (2Hz) is faster than charging
normally (1Hz)), which indicates the battery temperature is higher than 50°C. As soon as the permitted
temperature is reached, the battery charger will automatically switch to charging.
6. After continuous or repeated charging cycles without interruption, the charger may warm up. This is normal
and does not indicate a technical defect of the battery charger.
®
battery chargers. The battery charger supplied is specifically designed for
20