Read First  Safety Information - SEFRAM MW3035 User Manual

 Warning
Safety sheet
. . . . . . . . . .
. . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . .
. . . . . . . .
. . . . . . . . .


Safety Information
Understand and follow operating instructions carefully.
 WARNING
- Individual protective equipment should be used if
HAZARDOUS LIVE parts in the installation where
measurement is to be carried out could be
ACCESSIBLE.
- If the equipment is used in a manner not specified by
the manufacturer, the protection provided by the
equipment may be impaired.
- Always use proper terminals, switch position, and range
for measurements.
- To reduce the risk of fire or electric shock, do not expose
this product to rain or moisture.
- Verify the Meter operation by measuring a known volt
age. If in doubt, have the Meter serviced.
- Do not apply more than the rated voltage, as marked on
Meter, between terminals or between any terminal and
earth ground.
- To avoid false readings that can lead to electric shock
and injury, replace battery as soon as low battery
indicator.
- Do not use Meter around explosive gas or vapor.
- When using test leads or probes, keep your fingers
behind the finger guards.
- Remove test lead from Meter before opening the battery
door or Meter case.
- Use caution with voltages above 30Vac rms, 42 Vac
peak, or 60Vdc. These voltages pose a shock hazard.
- Probe assemblies to be used for MAINS measurements
shall be RATED as appropriate for MEASUREMENT
CATEGORY III OR IV according to IEC 61010-031 and
shall have a voltage RATING of at least the voltage of
the circuit to be measured.
- Disconnect circuit power and discharge all high-voltage
capacitors before testing resistance, continuity, diodes,
or capacitance.
1
Read First