Table of Contents
Advertisement
en
1.4
Fluids hazardous to health
In stagnant water (e.g. pump sump, soakaway,
etc.) germs which are hazardous to health can
form. There is a danger of bacterial infections!
Clean and disinfect the product thoroughly
ƒ
after removal!
Inform all persons about the pumped fluid
ƒ
and the danger it poses!
1.5
Personal protective equipment
Wear the following protective equipment dur-
ing transport, installation, removal and main-
tenance:
Safety shoes: Protection class S1 or P1
ƒ
Protective gloves (EN 388): Category II,
ƒ
marking 3131X
Wear the following protective equipment dur-
ing cleaning operations:
Protective gloves (EN ISO 374-1): Category
ƒ
C
Safety goggles (EN 166): uvex skyguard NT
ƒ
(Identification marking: W 166 34 F CE)
Breathing protection mask (EN 149): 3M
ƒ
Series 6000 with filter 6055 A2
1.6
Transport and storage
Wear protective equipment!
ƒ
Always carry the product by the handle.
ƒ
Never carry or pull on the connection cable!
Clean product and disinfect if necessary!
ƒ
Dirt fosters the formation of germs.
–
Encrustations may lead to the impeller be-
–
coming blocked.
1.7
Installation
Wear protective equipment!
ƒ
Do not install damaged or defective
ƒ
products.
If there is a risk of germ formation, observe
ƒ
the following points:
Ensure sufficient air exchange.
–
Wear a breathing protection mask e.g. 3M
–
Series 6000 with filter 6055 A2
6
Safety
1.8
Electrical connection
Do not connect products with a damaged
ƒ
connection cable! Have the connection cable
replaced by a qualified electrician or the cus-
tomer service.
Mains connection with correctly installed
ƒ
protective earth conductor.
Install the residual-current device (RCD) with
ƒ
30 mA.
Fuse protection at mains connection: max.
ƒ
16 A.
Product without plug: Electrical connection
ƒ
must be carried out by a qualified electrician!
1.9
During operation
The pumping of highly inflammable and ex-
ƒ
plosive fluids (petrol, paraffin, etc.) in their
pure form is strictly prohibited!
If persons come into contact with the
ƒ
pumped fluid (accessible basins*), do not
commission the product.
*Definition of "accessible basins"
Installation sites that can be walked on and
directly accessed without tools (e.g. ladders):
Garden ponds
ƒ
Paddling pools
ƒ
Cesspools
ƒ
Fountains, etc.
ƒ
NOTICE! The specifications applicable to
swimming pools also apply to accessible
basins.
1.10 Removal
Wear protective equipment!
ƒ
Product without plug: Have the connection
ƒ
cable disconnected from the mains by a
qualified electrician.
Depending on the operating mode and dura-
ƒ
tion, the housing parts become hotter than
40 °C (104 °F).
Only touch the product by the carrying
–
handle.
Allow product to cool down.
–
Clean the device thoroughly.
ƒ
WILO SE 2021-01
Advertisement
Table of Contents
