Table of Contents
Advertisement
Vorrang (priority)
As your receiver has 2 separate reception units but
only 1 decoder socket, the decoder socket has been
assigned at the factory to the reception unit A (set-
ting: "Decoder: Vorrang A").
1
In order to make a connected decoder also available
to the reception unit B, you must give priority to the
reception unit B for the programme positions con-
cerned.
For this, select for the programmes which can be
decoded by your decoder "Decoder: Vorrang B" in
the first line of this sub-menu.
As soon as the corresponding programme is selec-
ted on reception unit B, the decoder will decode this
programme.
If the decoder decodes only one programme (e.g.
Première), no restrictions exist for reception unit A.
The decoded signal can also be displayed with
reception unit A.
If the decoder can decode several programmes
(many English programmes operate with the
Videocrypt system, for example), "Decoder: Vor-
rang B" must be selected for each of these pro-
grammes.
!
If one of these programmes is selected on recep-
tion unit B, no other encoded programme can be
received with reception unit A.
!
After recording an encoded programme via recep-
tion unit B you should therefore always switch back
to a non encoded programme to make the decoder
available for reception unit A again.
Decoder norm selection
1
In the "Norm" menu line, you can switch the video
signal for the decoder between FBAS, linear base-
band, and PAL baseband (deemphasis). Certain
decoders require these signal settings for correct
operation.
Video/audio decoding
1
In the "Signal" menu line, you can select whether
only the video signal or the video and the audio
signal is to be decoded.
❒
Selecting LNB oscillator frequencies
LNB LO:
1 (9750)
1
Use the
keys to select between 4 preset LO
x c
frequencies (the frequency value is shown between
brackets).
2
It is possible to change the preset LO frequency
values in a sub-menu (see following section).
❒
Preselecting LNB oscillator frequencies
LO 1
:
1
To change the preselected LO frequencies, press
the
key when in the "LNB LO" line of the
.
MENUE
main menu.
LNB LO 1
:
LNB LO 2
:
LNB LO 3
:
LNB LO 4
:
LNB Spg
:
0 . . 9
TXT = Exit
Enter the frequency directly with the numeric keys
2
or change it step by step with the
Use the ] | keys to go to the other LO frequency
3
lines and repeat the setting.
For satellites broadcasting in the 2.5 and 4 GHz
range, LNB's are used which produce a "negative"
picture. In this case, select the "neg" menu option
to get a "normal" picture on the screen.
A negative ("neg") video polarity is automatically
4
asssigned to LO
frequencies below 7000 MHz
and a positive ("pos") video polarity to higher
frequencies.
5
You can change the polarity by pressing the red
k
key.
9,750 GHz pos
9,750
GHz
pos
9,750
GHz
pos
10,600
GHz
pos
11,475
GHz
pos
14/18 Volt
rot = pos/neg
OK = Store
keys.
x c
13
Advertisement
Table of Contents
