Table of Contents
Advertisement
Opening the Special Menu
The special menu is provided for changing various
basic settings. In order to prevent an inadvertent
change of these settings, the access to this menu
has been made more difficult.
To access the special menu, first switch the receiver
1
to stand-by by pressing the
2
Then press the
The special menu is displayed.
IR Ebene
Security
Modulator
Scart DEC
Volume
TXT = Exit
Changing the Remote Control Mode
If you use two GRUNDIG SAT receivers in the same
room, you should switch one receiver to the second
remote control mode. Only then the two receivers
can separately be controlled.
The remote control mode of the STR 622 TWIN can
be changed as follows:
Open the special menu as described further up.
1
2
Use the
control mode (1 or 2) in the first menu line.
Store with
3
4
To give remote control commands in the second
control mode, press and hold down the
while pressing the desired function key(s).
20
key.
b
key for 5 seconds.
.
MENUE
:
SAT 1
:
. . . .
:
C 38
A
:
Decoder
:
31
x c
keys to select the desired remote
O
.
❒
1
2
3
OK = Store
❒
1
❒
1
2
¢
key
SAT 2
3
Security Function
At the factory the security function is deactivated.
Activating the security function
Open the special menu as described further up.
When the security function is deactivated, "Security
: . . . ." is displayed in the second menu line. The
four dots indicate that no security code is stored.
Use the | key to select this line and enter the four-
digit code with the numeric keys.
Be sure to remember the code number or note it
down and keep it in a location which is accessible
only to you.
After the code entry, "Security : 7 2 8 4", for exam-
ple, is displayed in the second menu line.
Press the
O
key to store the code. This activates
automatically the security function.
"Security : * * * *" is shown in the menu line. The
four asterisks indicate that a four-digit security
code is stored. The security function is activated
and the picture background is red.
The receiver can be switched to stand-by by pres-
sing the
key.
b
When the security function is activated
When switching on the receiver from stand-by,
"Security : . . . ." appears on red background on the
picture screen.
Enter your four-digit security code.
You now have access to all programmes until you
switch the receiver to stand-by again.
Deactivating the security function
Open the special menu as described further up.
When the security function is activated,
"Security: * * * *" appears in the second menu
line.
Use the | key to select this line and enter the four-
digit code with the numeric keys.
After entering the correct code number,
"Security : . . . ." appears in the second menu line.
Press the
O
key to deactivate the security func-
tion and to clear the code number.
Advertisement
Table of Contents
