Certificates And Approvals; Installation; Incoming Acceptance, Transport, Storage - Endress+Hauser RIA45 Brief Operating Instructions

RIA45
2.3

Certificates and approvals

CE mark, Declaration of Conformity
The device is designed to meet state-of-the-art safety requirements, has been tested and left the
factory in a condition in which it is safe to operate. The device meets the relevant standards and
directives as per IEC 61 010-1 "Safety requirements for electrical equipment for measurement,
control and laboratory use".
Thus, the device described in these Operating Instructions meets the legal requirements of the
EU directives. The manufacturer confirms successful testing of the device by affixing to it the CE
mark.
An overview of all the certificates and approvals available can be found in Section 10 "Technical
data".
3

Installation

3.1

Incoming acceptance, transport, storage

The permitted ambient and storage conditions must be observed. The precise specifications can
be found in Section "Technical data".
3.1.1 Incoming acceptance
On receipt of the goods, check the following points:
• Are the packaging or contents damaged?
• Is anything missing from the delivery? Compare the scope of delivery with the information
you specified in the order.
3.1.2 Transportation and storage
Note the following points:
• Pack the device so that is protected against impact for storage and transportation. The original
packaging provides optimum protection.
• The permitted storage temperature range is -40 to +85°C (-40 to +185 °F); it is possible to
store the device in the limit temperature ranges for a limited period (maximum 48 hours).
Endress+Hauser
Installation
27