Dimmer Function - Electrohome EAAC200 Quick Start Manual

4. Set the alarm ringtone:
a. Make sure the alarm time (region
flashing during the following steps. If it is
not, follow step 2 above.
b. Press the button (
through three ringtone options: Off,
Radio , and Buzzer
Note: pay attention to the green dots in
the region as follows.
c. Press the
the setting.
Note: the clock will stop flashing and
show the current time. For example, the
following figure shows that the current
time is 6:34 PM, and the alarm clock # 1
is set to use Buzzer as the ringtone.
5. (Optional) Set more alarms:
a. You can set up to 2 alarms at the same
time. To set up the alarm clock #2, just
press the
Setting Mode, cycle through the alarm
ringtone options in step 2-4, and look
at the region
indicator of ringtone option described in
step 4.
6. Snooze, Stop or Cancel the alarms:
a. Snooze: when the alarm is ringing,
press the
4
) to cycle
.
button ( ) to confirm
button ( ) to enter the
on the right side for the
button(
) is
b. Stop: when the alarm is ringing,
c. Cancel: if you want to cancel the
Sleeper
1. Press the
2. Press and hold the SNOOZE/SLEEP/DIM
button. The display will show 90 minutes,
your clock radio will turn off in 90 minutes.
3. To change the number of minutes for the
SLEEP timer, press the SNOOZE/
SLEEP/DIM button until you see the
desired number of minutes. The SLEEP
timer decreases in increments of 10.
4. To cancel the SLEEP timer, press and hold
the SNOOZE/SLEEP/DIM button then
press again until you see OFF in the display
or press the

Dimmer Function

1. Press the SNOOZE/SLEEP/DIM button to
toggle between the 3 LED brightness
settings.
) to
temporarily pause the alarm for 9
minutes.
Note: The alarm will ring again after
9 minutes.
press the button ( ) to stop the
alarm without snoozing.
Note: the alarm will still ring in the
set time in the future.
alarm, follow step 2 to enter the
Setting Mode, and then follow step
4 to set the ringtone option as off.
button once to turn radio ON.
button.