Installing A Serveraid M5000 Series Advanced Feature Key; Installing The Serveraid M5000 Series Advanced Feature Key On The Serveraid M5015 Sas/Sata Controller; M5000 Series Advanced Feature Key - IBM ServeRAID M5014 User Manual

8.1 Installing the ServeRAID M5000 Series Advanced
Feature Key on the ServeRAID M5015 SAS/SATA
Controller
Chapter 8
Installing a ServeRAID
M5000 Series
Advanced Feature Key
The ServeRAID M5000 Series Advanced Feature Key enables support
for RAID 6 configurations and self-encrypting disks (SED) on the
ServeRAID M5015 SAS/SATA controller.
The ServeRAID M5000 Series Advanced Feature Key mounts directly to
the controller using the J1 2-pin connector. The following figure shows
the ServeRAID M5000 Series Advanced Feature Key.
Figure 8.1

M5000 Series Advanced Feature Key

Note: It is important to back up any data before you make a
change in system configuration. Failure to do this could
result in data loss.
Perform the following steps to install the ServeRAID M5000 Series
Advanced Feature Key directly to the ServeRAID M5015 SAS/SATA
controller.
1. Turn off the computer and unplug the power cords from the rear of
the power supply.
ServeRAID M5014/M5015 SAS/SATA Controller User's Guide
J1
85060-00
8-1