IBM ServeRAID M5014 User Manual page 59

3 - J2 connector
4 - Battery pack harness
CAUTION:
The battery is a lithium ion battery. To avoid possible explosion, do not
burn. Exchange only with the IBM-approved part. Recycle or discard the
battery as instructed by local regulations. In the United States, IBM has a
process for the collection of this battery. For information, call 1-800-426-
4333. Have the IBM part number for the battery unit available when you
call. (C007)
If the ServeRAID M5014 controller is already installed in a computer,
follow these steps to remove it before you install the battery assembly:
1. Shut down the computer, turn off the power, and unplug the power
cords.
2. Remove the cover from the computer according to the instructions in
the system user's manual so you can access the controller.
3. Ground yourself before you touch the controller.
4. Unplug all cables from the controller, remove the screw attaching the
bracket to the computer case, and carefully remove the controller
from the slot.
5. Place the controller on a flat, clean, static-free surface, and continue
with the next section.
Perform the following steps to mount the battery assembly directly to the
controller using the daughtercard. (All components are installed on the
bottom of the card. The battery is installed on the top. The maximum
height of components installed on the battery assembly is 0.125".)
1. Ground yourself, and remove the daughtercard from the package.
2. Insert the battery pack harness into the 5-pin J4 connector on the
bottom of the battery assembly.
Installing the ServerRAID M5000 Series Battery Assembly on a Controller 5-3