Using V-Drive; Assembling V-Drive On Your Wheelchair - Vermeiren V-Drive User Manual

EN
NL
3

Using V-drive

CAUTION
• First read previous chapters and inform yourself about the intended use. Do NOT use your
wheelchair with V-drive unless you have read and fully understood all instructions.
• Make sure that the anti-tipping on your wheelchair has been lowered.
• In case of doubts or questions, do not hesitate to contact your local specialist dealer, your care
provider or technical adviser to help you with this.

3.1 Assembling V-drive on your wheelchair

3.1.1 Installing the operating console
1. Push the operating console (1) forwards to remove it from
the clamp (2).
2. Loosen both screws (3) of the clamp and position it around
the tube of your wheelchair handle. Use the circular rubber
(4) if the wheelchair tube is too thin.
Tighten the clamp around the wheelchair handle by
3.
tightening both screws.
Slide the console (1) back on the clamp.
4.
3.1.2 Installing the support brackets
1. Install both brackets on the bottom horizontal tubing of
the wheelchair, just behind the cross attachments (5),
by firmly tightening the screws.
2. Attach the strap (6) between the brackets.
3. Ensure that the screws (7) are sufficiently tight and do
not rotate on the tubing.
3.1.3 Installing the V-drive module
1. Slide the telescopic bar (8) through the front end of the V-drive module. Loosen the star knob
(9) on the bar and adjust to the correct length.
2. Tighten the knobs on the bar (9) and at the front of the V-drive module (10).
3. Place the two ends of the bar on the rear of the brackets, then push the V-drive module
forward until it locks into position.
4. Connect the cable from the V-drive module to the one the underneath the handset (11).
5. Place the top loop of the lifting strap around the opposite push handle to the handset (12).
Risk of injuries
6
V-drive
2021-05
Using V-drive
2
3
4
6
7
5
1