Advertisement
Wiring diagrams
For bus wiring details, refer to the Keypad Bus Wiring Guide (
Operation and configuration
On initial power up, all status LEDs on the keypad will illuminate green, indicating
that the device has power. Until the keypad has been configured into a Control4
system, it will not control any loads. To set up this keypad for use with a Control4
system, refer to the Composer Pro User Guide (
Button tap sequences
The button tap sequences are defined in the table below. Button tap sequences
that require a single button should use the top-most button installed on the
keypad. Button tap sequences requiring two buttons should use the top-most and
bottom-most (or bottom-left) buttons installed on the keypad.
Function
Identify
Reboot
Factory Reset
Unidentify
Troubleshooting
If the LEDs do not light up indicating that the keypad is receiving power:
•
Ensure that the Bus Power Supply is powered on.
•
Ensure that the Bus Ethernet Gateway is powered on and connected.
•
Check for proper wiring (see "Installation instructions" above).
•
For help on the installation or operation of this product, email or call the
Control4 Technical Support Center. Provide your exact model number. Contact
support@control4.com or see
Care and cleaning
Do not paint the keypad or its wall plate.
•
Do not use any chemical cleaners to clean the keypad.
•
•
Clean surface of the keypad with a soft damp cloth as needed.
Regulatory/safety information
To review regulatory information for your particular Control4 products, see the
information located on the Control4 website at
Warranty
For complete warranty information, including details on consumer legal rights as
ctrl4.co/warranty
well as warranty exclusions, visit
Patent information
Applicable patents are available at
ctrl4.co/buswiring
ctrl4.co/cpro-ug
).
Button sequence
4
15
9-4-9
13-4-13
www.control4.com
.
ctrl4.co/reg
.
.
ctrl4.co/patents
).
Copyright ©2020, Wirepath Home Systems, LLC. All rights reserved. Control4 and Snap AV and
their respective logos are registered trademarks or trademarks of Wirepath Home Systems, LLC,
dba "Control4" and/or dba "SnapAV" in the United States and/or other countries. Snap AV and
Wirepath are also registered trademarks or trademarks of Wirepath Home Systems, LLC. Other
names and brands may be claimed as the property of their respective owners. All specifications
subject to change without notice.
200-00346-D 2020-02-17 MS
Advertisement
