RH Teen BAROQUE CARVED WOOD DRESSER MIRROR Quick Start Manual

BAROQUE CARVED WOOD DRESSER MIRROR - ASSEMBLY INSTRUCTIONS
PARTS INCLUDED :
A [1] BAROQUE CARVED WOOD DRESSER MIRROR
B [1] HANGMAN (FOR WALL)
Note: This hanging system is meant for drywall stud mounting only. If walls are concrete, brick or plaster, please consult
your local hardware store for assistance. For safety and ease of mounting,
PROFESSIONAL INSTALLATION RECOMMENDED
Tools needed:
Electronic stud finder, #2 Phillips screwdriver, drill with #2 Phillips bit, pencil
Mounting Instructions:
1. Determine the desired placement on the wall for the wall panel (frame can be hung only vertically). Within the desired
mounting location, locate the wall studs using the electronic stud finder and mark stud locations using the pencil. (Note:
I t is best to mount the bracket to at least one stud, using the illustrative graph shown above for reference.)
2. Determine which wall-mount bracket hole or holes on the wall will be centered on the stud. The hole positions that are
centered over studs will use the Stud Mounting Screws for mounting the bracket.
3. Insert the included Bubble Level
4. Place the wall-mount bracket at the desired location on the wall and confirm that the bracket is level.
5. Using the pencil, mark the mounting screw hole locations on the wall.
6. Remove the wall-mount bracket and set aside.
Stud Mounting:
1. Install the wall-mount bracket onto the wall using the Stud Mounting Screw at one of the stud locations first, using the #2
Phillips screwdriver or the drill with a #2 Phillips bit.
2. Insert the firs t Stud Mounting Screw through the hole in the wall-mount bracket and tighten clockwise. Leave the S tud
Mounting Screw slightly loose so that the wall-mount bracket can still be rotated and the wall-mount bracket area on the
wall is exposed for installing the drywall toggle anchor(s).
Drywall Mounting:
1. Use the #2 Phillips screwdriver to install the toggle anchor(s).
Hanging the Product:
1. On the back of the wall panel is an affixed product-mounting bracket.
2. Carefully position the product-mounting bracket over the wall-mount bracket, ensuring that the two brackets are aligned.
3. Press down firmly to engage the two brackets.
4. Your product is ready for use.
NO.
1
2
3
4
5
6
into the Bubble Level track, as close to the center of the wall-mount bracket as possible.
ITEM
DESCRIPTION
Toggle Anchors
Toggle Screws
Stud Mounting Screws
Toggle EZ Mini Anchor
Toggle EZ Screw
Bubble Level
two people are recommended for installation.
EZ Mini
QTY
2 Pcs.
2 Pcs.
12 Pcs.
2 Pcs.
2 Pcs.
1 Pc.
EZ Mini